Add to Favorites | Chinese
10 when to power source product you should know practical clew
From;    Author:Stand originally
Improve the simple method that you are operated and measures ability

Clew the 1 influence that compensates laden down-lead with far induction
Power source is in when leaving factory, its adjustment inductive end is received normally go up to output end. The voltage that makes meeting limitation power supply so adjusts ability, even if when very short down-lead. Use longer lead or higher wire gauge mark to be able to make adjust ability worsen (graph 1) . With the 0.2m Ω of 10A power source output impedance photograph is compared, the impedance of cupreous down-lead is:

Ω of M of resistor of   of   of date of AWG wire gauge / Ft (20OC)
  of   of   of   of   of   of 22   16.1
  of   of   of   of   of   of 20   10.2
  of   of   of   of   of   of 18   6.39
  of   of   of   of   of   of 16   4.02
  of   of   of   of   of   of 14   2.53
  of   of   of   of   of   of 12   1.59
  of   of   of   of   of   of 10   0.999

If use relay to receive load power source, adjust ability to be met even more flooey.
Far induction, feedback power source interior namely the inductive end of amplifier receives load directly, can let power source be carried in load thereby, is not in his output end adjusts output (graph 2) . Voltage compensates the resistor of laden down-lead, relay or connector through necessary deflection, maintain constant laden tension thereby.

To realize far induction, disconnect output carries what carry with the induction to connect a line. The induction that gets on termination of power source induction to load nods the cable of double skeining thread that uses screen (do not regard an induction as conductor with screen) . the ground connection of one aspect of the matter of screen, another end is impending.
Faradic be less than 10mA normally, as general regulation, you should control inductive route mediumly fall maintain to be less than power source temperature coefficient (express with MV/ ° C normally) 20 times. The crewel cable of use screen satisfies this one requirement very easily.

Clew 2 charge for batteries inside shorter time and discharge
The constant current mode of use power source (graph 1) it is the simple method that charges afresh to batteries, it can come true of 100% charge. But charge slow the one big drawback that is this kind of method, because charging current is batteries only rated an odd that brings value, because this charges,can need 14-16 hour.
Pulse charges to also call transient mode, it can shorten charge time, fill cell to 90% above capacity (graph 2) . Electronic load offers voltaic pulse as switch (notice you also can use constant current of electronic load process designing to charge) . Graph 3 show the weaveform of pulse charging current that gives a typical case.
Previous12 Next

About us | Legal Notices | Sitemap | links | Partner